Difference between revisions of "ART tracker"
From Immersive Visualization Lab Wiki
(page setup) |
(→Turn on/off Cameras in WAVE) |
||
| (5 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | =Recalibrating Tracking in the StarCAVE= | |
| + | |||
| + | * Switch KVM to tracker PC (PC2) | ||
| + | |||
| + | Camera numbers: | ||
| + | |||
| + | * 1 = left | ||
| + | * 2 = on door | ||
| + | * 3 = front center | ||
| + | * 4 = right | ||
| + | |||
| + | Calibration mode: Powerwall | ||
| + | |||
| + | Placement of L-shape: corner in center of cave, long edge pointing right, short edge pointing to front wall (edge between walls) | ||
| + | |||
| + | =Turn on/off Cameras in WAVE= | ||
| + | |||
| + | The tracking cameras should only be running when the WAVE is being used. Otherwise the IR emitters will wear prematurely. | ||
| + | |||
| + | Start: | ||
| + | |||
| + | <tt>echo -n "/home/calvr/Downloads/DTrack2_v2.9.4/DTrack2 tracking start" | nc smarttrack-00057 50105</tt> | ||
| + | |||
| + | Stop: | ||
| + | |||
| + | <tt>echo -n "/home/calvr/Downloads/DTrack2_v2.9.4/DTrack2 tracking stop" | nc smarttrack-00057 50105</tt> | ||
Latest revision as of 15:11, 13 April 2016
Recalibrating Tracking in the StarCAVE
- Switch KVM to tracker PC (PC2)
Camera numbers:
- 1 = left
- 2 = on door
- 3 = front center
- 4 = right
Calibration mode: Powerwall
Placement of L-shape: corner in center of cave, long edge pointing right, short edge pointing to front wall (edge between walls)
Turn on/off Cameras in WAVE
The tracking cameras should only be running when the WAVE is being used. Otherwise the IR emitters will wear prematurely.
Start:
echo -n "/home/calvr/Downloads/DTrack2_v2.9.4/DTrack2 tracking start" | nc smarttrack-00057 50105
Stop:
echo -n "/home/calvr/Downloads/DTrack2_v2.9.4/DTrack2 tracking stop" | nc smarttrack-00057 50105
